Handguns

(GunReports.com) – Charter Arms has added the Off Duty .38 Special and Undercover Lite .38 Special models to its line of personal-defense revolvers. Both models are available with high-polish-stainless-steel finishes with matte-black frames. They debuted at the National Association of Sporting Goods Wholesalers Annual Meeting and Expo in Louisville, Ky.

Check out these new videos on GunReports.com:* Larry Potterfield, Founder and CEO of MidwayUSA, demonstrates the process of installing a set of Uncle Mikes brand swivel studs in a Winchester Model 67 riflestock.* NSSF's Lawrence G. Keane responds to recent erroneous news reports concerning America's firearms industry and Mexico.* The VTAC Battle Belt adapts to a wide range of holsters and accessory pouches.

As recently as the September 2010 issue of Gun Tests, we referred to our evaluation of two similar 1911 45s as being something of a rarity. That's because the guns were essentially a different interpretation of the same design. More often, we compare a roster of test guns that, despite being of the same caliber and approximately the same size, end up demanding widely different skill sets to operate.

In this test we once again evaluate two closely related firearms chambered for 45 ACP ammunition. They are the $709 Springfield Armory XDM 45 XDM945BHC and the $712 SIG Sauer P250 45 Full Size 250F-45-BSS. Both pistols are full-sized guns with polymer frames and a barrel length of 4.5 inches. Each gun offers an accessory rail, low-mount sights, double-column magazines, and a measure of ambidextrous features.

On the surface it would seem that this was indeed another "apples to apples" test. But one noteworthy difference between the two pistols puts these guns in different categories, we believe. The trigger on the XDM 45 requires a takeup and press that was much shorter than that of the SIG Sauer P250 45. That was because the striker inside the XDM 45 is primed to a point just short of ignition by movement of the slide. However, the XDM 45 is categorized as a double-action pistol. This is based on the actions of pressing the trigger renders final compression and release of the striker. In a more obvious display of double-action form, the SIG Sauer operator has almost complete control of the ignition cycle. Pressing the P250's trigger rearward results in nearly a 1:1 ratio in terms of lifting the hammer and dropping it on the firing pin. Some shooters may find this difference too much to overcome, smashing our presentation as a test of similar guns. But as shown by the results of our rapid-fire tests, our staff found that both triggers could be operated quickly and effectively.

Our tests for accuracy were performed from a bench at the Top Gun of Texas indoor shooting range, www.topgunrange.com. We took full advantage of Top Gun's 20-yard bays and the slick mechanical target retrieval system recently installed by Action Target. Away from the heat and marauding showers in the Texas outdoors, we liked the privacy and safety afforded by the sizable ballistic barriers that separated us from other shooters. Accuracy testing was a slow-fire exercise, but we used an electronic timer to record our first shot and total elapsed times during our two action tests. Our first action test was performed from the 7-yard line with the shooter holding the gun in both hands and the front sight held at the lower edge of the shooter's peripheral vision. Our target was the IPSC-P (paper) targets from www.letargets.com. The action consisted of firing two shots to the body (a 5- by 9-inch rectangle A-zone), and one to the head. The head area measured 6.9 by 6.3 inches overall with a 4-inch-wide by 2-inch-tall A-zone, which on a human target terms would mask the eyes. We recorded ten separate runs.

In our second action test we wanted to know more about keeping the gun mounted in the hand throughout rapid fire. So, for this test the start position was with the gun directly on target held only in the shooter's strong hand. This meant our right-handed test shooter fired holding the gun with only the right hand. The IPSC-P target was placed 5 yards downrange and we concentrated on head shots only. Five runs of two shots each were recorded.

Test ammunition included 185-grain and 200-grain Hornady Custom XTP jacketed hollowpoint rounds. We also tested with the least expensive rounds we could find. They were Federal 230-grain FMJ rounds purchased for less than $17/50 from Walmart. Our action tests were performed using the 200-grain Hornady ammunition. Here's how we rated them:

In our first review of handguns suited for the SASS Wild Bunch category—named in deference to the Sam Peckinpah movie, The Wild Bunch—we covered five traditional GI-type handguns from Springfield Armory, High Standard, and Colt. Prices ranged from $500 to $1000, a fairly large spread. In the 'modern' class of 45s we tested, quite a few SASS members probably already own such a handgun, and interested shooters from other disciplines may jump in to shoot Wild Bunch matches. In this class, we tested the Springfield Loaded Model PX9109LP 45 ACP, $1035, which was more than a GI pistol with good features.

GunReports.com video from Crimson Trace: Conquering Low Light with Ken Hackathorn. Ken shows how the use of white light and laser sights can make you a better shooter in conditions most common in personal defense situations.

Improve your speed when removing and replacing your magazine in pressure scenarios with minimized, smooth movements. The speed at which you remove and replace your magazine in a fire fight can mean the difference between victory and disaster.

There are several versions of the Ruger MKIII, but we chose one of the plainest, with the 6-inch barrel. This blued Ruger was exceptionally well balanced, something we all noticed right away. We all loved the feel of the grips, too. The grip angle seemed just right for most of us, and the checkered plastic panels were mighty comfortable as well as functional.We’ve handled the 4-inch version of the Ruger Standard in the recent past and it didn’t balance nearly as well for us. The Ruger Standard is the gun that put Sturm, Ruger & Co. on the map. Introduced in 1949 and selling for $37.50 for many long years, it provided the background and basic building blocks for today’s huge Ruger operation. We’re not sure how many Ruger Standards have sold, but the numbers passed the million mark back in 1979. There have been a few changes to the gun over the years, and most changes may be seen as improvements. We found a few items of contention, however. First, the good stuff.

In this test we evaluate three 40 S&W polymer handguns that offer significant changes to their original designs. In the case of the $530 Smith & Wesson SD40, the SD40 and its new trigger provide an upgraded version of the Sigma pistol. Glocks $649 G22 Gen 4 is an optional version of the G22 series pistol, with an aggressive grip texture and a choice of three different backstraps. Heckler & Kochs $1005 P30 V3 adds an ambidextrous thumb safety to the latest edition of that companys newest polymer platform. According to Smith & Wesson representatives, the primary difference between the Sigma and SD pistols was the latters lighter trigger-pull weight. We can recall testing several of the original striker-fired pistols that simply wore out the shooter who had to pull a long, heavy trigger. Many years later, improved springs and improved mechanisms have made all the difference. We measured our SD40s trigger to present about 7.5 pounds of resistance. It seemed somewhat lighter because after a takeup of about 0.3 inches, true compression was smooth and relatively short.One of the most popular handguns for law-enforcement personnel is the Glock Model G22. The G22 is a full-size handgun that fires from a 4.49-inch barrel. Since the introduction of the Glock pistol, there have been only subtle changes, and most people still think of the Glock as being available without options or variation. But weve been able to purchase different models with upgrades to the trigger, sights, slide release, magazine release, and other operational components. Also, at www.teamglock.com, we found another lineup of RTF pistols that offer streamlined grips with a radical surface texture-but the Gen 4 Glock pistols go even further. They offer an aggressive grip texture and a choice of three different backstrap profiles. The Gen 4 pistols include the 9mm G17 and G19, the .357 SIG G31, and the 45 GAP G37.Most polymer handguns are simple in design. Rather than call the HK P30 more complex, well use the word sophisticated. There are six variants of the P30 series pistol- seven if you count the suffix "S" for ambidextrous safety. In our December 2007 evaluation of the 9mm Heckler & Koch P30 V3, we began our Gun Tests Report Card by saying: "Based on the fine accuracy we achieved firing single-action only, maybe this is a gun that should have a thumb safety rather than a decocker." The P30S V3 pistol in this test adds an ambidextrous thumb safety.

The double-action first-shot self-loading pistol continues being popular because many shooters are uncomfortable with the requirement to keep a single-action pistol cocked and locked, hammer back, safety on. Others do not trust the lack of a manual safety in the double-action-only pistol. These shooters are more comfortable with a long first-shot double-action trigger press. The double-action first shot seems to offer the best of both worlds. This is a prime example of handling features taking advantage over range performance. The double-action-first-shot pistol will never win a combat competition, but many personal-defense shooters favor it. The long double-action trigger is a safety feature that requires 10 pounds or more of pressure to fire the handgun. If you need real precision, you have the option of a crisp single-action trigger press. The double-action-first-shot action transferred to the polymer-frame handgun offers light weight, low maintenance, and low expense, and two pistols like that we tested recently were the FNH-USA FNP-9 USG Flat Dark Earth (FDE) 9mm, $599, and the CZ-USA CZ P07 Duty No. 91186 9mm, $575. Each was individual enough that there were clear choices based on personal preference, but we were also struck by how similar these pistols are. The magazines, hammers and even many of the internal parts were similar in appearance.Each handgun represented a different viewpoint. The FNH pistol is probably better suited as a holster gun for the Armed Services or as a home defender than for concealed carry, although it is light enough for concealed carry. The CZ may be better suited as a concealed carry handgun. Neither is a small pistol. The FNH is a result of the Armed Services requests for new pistol designs, although no contract test program or clear outline for specifications is forthcoming. No maker wishes to be left out of these competitions if they emerge. The pistol is available in 9mm, 40 S&W and 45 ACP. The CZ is an update in polymer of the proven CZ 75 design, with the new Omega action.We tested each in 9mm Luger caliber. The 9mm is still an immensely popular handgun, and improvements in bullet technology and the availability of 9mm +P and +P+ loads make the caliber suitable for personal defense. Truth be told, in such light handguns the 9mm caliber is all the average shooter is probably willing to master.

The double-action first-shot self-loading pistol continues being popular because many shooters are uncomfortable with the requirement to keep a single-action pistol cocked and locked, hammer back, safety on. Others do not trust the lack of a manual safety in the double-action-only pistol. These shooters are more comfortable with a long first-shot double-action trigger press. The double-action first shot seems to offer the best of both worlds. This is a prime example of handling features taking advantage over range performance. The double-action-first-shot pistol will never win a combat competition, but many personal-defense shooters favor it. The long double-action trigger is a safety feature that requires 10 pounds or more of pressure to fire the handgun. If you need real precision, you have the option of a crisp single-action trigger press. The double-action-first-shot action transferred to the polymer-frame handgun offers light weight, low maintenance, and low expense, and two pistols like that we tested recently were the FNH-USA FNP-9 USG Flat Dark Earth (FDE) 9mm, $599, and the CZ-USA CZ P07 Duty No. 91186 9mm, $575. Each was individual enough that there were clear choices based on personal preference, but we were also struck by how similar these pistols are. The magazines, hammers and even many of the internal parts were similar in appearance.Each handgun represented a different viewpoint. The FNH pistol is probably better suited as a holster gun for the Armed Services or as a home defender than for concealed carry, although it is light enough for concealed carry. The CZ may be better suited as a concealed carry handgun. Neither is a small pistol. The FNH is a result of the Armed Services requests for new pistol designs, although no contract test program or clear outline for specifications is forthcoming. No maker wishes to be left out of these competitions if they emerge. The pistol is available in 9mm, 40 S&W and 45 ACP. The CZ is an update in polymer of the proven CZ 75 design, with the new Omega action.We tested each in 9mm Luger caliber. The 9mm is still an immensely popular handgun, and improvements in bullet technology and the availability of 9mm +P and +P+ loads make the caliber suitable for personal defense. Truth be told, in such light handguns the 9mm caliber is all the average shooter is probably willing to master.

The P11 is a 9mm handgun with a 3.1-inch barrel. Capacity was 10+1, thanks to a double-column magazine. The suggested retail price of the base model was only $314 and featured a blued slide. Our P11 carried a hard-chromed slide and cost $368, but the same gun was available for $355 should you choose a P11 with a Parkerized finish. The inexpensive Kel-Tec P11 shared at least one design concept found on some more expensive pistols.

According to the manufacturer, the Glock pistol was the first "industrially manufactured handgun with high-tech polymer grips." The barrels and slides are coated with what Glock describes as a "high-tech surface refinement" that they call Tenifer. The benefits of this "carbonitriding" coating are not only corrosion resistance and reduced glare but also resistance to abrasion. Tenifer coating is highly rated on the Rockwell Cone hardness scale at 64 HRC.

Some Glock pistols are available with different color frames, but our G34 was basic black. The defining feature of the G34 was its long 5.3-inch barrel with polygonal rifling, covered by a slide that included a gaping hole just to the rear of the front sight. This relief measured approximately 1.75 inches long by 0.75 inches wide. Glock says that this serves to reduce stress on the frame. The dustcover beneath the slide was also longer, making room for a healthy sized accessory rail, which was molded into place. The schematic breakdown of the Glock pistol with magazine lists only 34 separate parts, 36 if you count the magazine insert at the base plate (part 32a), and the front sight blade, part number 16a.