When it comes to personal defense, no one should be priced out of the market. Yet with both young and old on a tight budget and struggling to stay afloat, a $1000 gun simply isn’t in the cards. If readers could purchase a handgun at a fair price and have funds left over for training, ammunition, and holsters, it would be a good thing. We wondered if it were possible to purchase a $300 handgun that provides the same degree of protection as a pistol costing twice as much. If you don’t need a box full of backstraps and multiple MOS red-dot mounting plates, you probably can get by just fine with spending less money. So we went shopping for 9mm Luger handguns.
Our first gun was a GForce RPX9 Exodus TAC GFRPX3C9BNZ, $314. GForce Arms is a relatively new importer located in Reno, Nevada. There are dozens of firearms listed on the company’s website, including several versions of the Exodus. Our pistol was available at Bud’s for $275. At Guns.com, the price was $341. A plainer handgun, all black without the bling of the burnt bronze model tested, costs $235 at Bud’s. We counted eight separate models for sale at Bud’s, all with different pricing. We paid $314 retail for the test pistol, which seems fair considering we would have paid shipping and FFL fees for an online order. With careful shopping, you may be able to obtain a GForce Exodus for less than $300, perhaps much less.
The Canik Mete SF Two-Tone HG5367, $475, seemed a perfect counterpoint to the GForce Exodus and the Glock 19 Generation 5, landing in the middle range of their prices. The pistol cost about $200 more than the Exodus, a hefty sum, but also costs $65 less than the Glock 19 Gen 5 tested alongside them. While also a striker-fired handgun with a polymer frame, the pistol differs from the others, primarily in trigger action. The striker load when the Canik is cocked is much greater than the two Glock-type handguns.
The third gun was the control, a Glock 19 Gen5 FS Black/FDE -PA195S203DE, $539. We have tested Glock 19 variants against several handguns. The reason is that the Glock 19 is a nicely-sized pistol for concealed carry. The Glock is also a striker-fired polymer-frame handgun. The slide is angular and features forward cocking serrations. The front of the slide is slightly beveled. All of the handguns tested feature this slight bevel; neither bevel is better than the others. The big difference in the Glock Generation 5 pistol is the Modular Optics System. The Glock is supplied with four plates that allow mounting practically any reflex sight. Specialty plates such as the ACRO are available from XS Sights and others. This versatility makes the Glock the number-one choice here for optics mounting, while the others work fine with the limited choice of direct-mount optics. If you are not using optics or you are not particularly picky considering the choice of red-dot sight, the MOS option doesn’t matter.
To test fire the three pistols, we originally intended to fire a 50-round box of CCI Blazer 115-grain FMJs and 20 rounds of Black Hills Ammunition 115-grain EXP jacketed hollow points. For accuracy testing, we used the CCI Blazer load, the Black Hills EXP, and Fiocchi 124-grain Covert X. We ran over the original allotment of ammunition, as we often do, to answer questions that came up.
GForce RPX9 Exodus TAC GFRPX3C9BNZ 9mm Luger,
$314
Gun Tests grade: B-
With its burnt-bronze finish and flashy slide treatment, the GForce Exodus is an attractive handgun. The pistol felt tight compared to the other handguns, which didn’t translate to better accuracy.

| Action | Semi auto recoil operated locked breech striker fired Safe Action |
| Trigger | Double-action only |
| Overall Length | 7.28 in. |
| Overall Height | 5.04 in. |
| Maximum Width | 1.4 in. |
| Barrel Length | 4.1 in. |
| Weight Unloaded | 20.5 oz. |
| Weight Loaded | 29.15 oz. |
| Slide | Burnt-bronze-finished steel |
| Slide Retraction Effort | 18.5 lbs. |
| Receiver | FDE polymer |
| Front Strap Height | 2.0 in. |
| Rear Strap Height | 3.6 in. |
| Grip | Pebble finish |
| Grip Thickness | 1.3 in. |
| Grip Circumference | 6.0 in. |
| Magazines | (2) 15 round |
| Magazine Price | $14 Magpul |
| Rear Sight | Fixed green twin fiber optic |
| Front Sight | Fixed red fiber optic |
| Trigger Pull Weight | 6.0 lbs. |
| Trigger Span | 2.6 in. |
| Sight Radius | 6.0 in. |
| Safety | Trigger lever |
| Warranty | Limited lifetime |
| Telephone | (833) 343-6723 |
| Website | GForceArms.com |
| Made In | Turkey |
One of our raters spotted the GForce Arms Exodus in a shop and felt that it might be a good handgun for those on a budget, so we took a hard look at it. While it is styled after the Glock 19, there are differences.
The pistol tested also features lightening cuts in the slide. These cuts, according to specifications in other Exodus handguns offered by GForce, reduce the pistol’s weight from 24 ounces to 21.2 ounces.
The pistol is imported from Turkey. The Exodus is a clone of the Glock 19 Generation 3 or Generation 4 in most particulars. The pistol takes Glock magazines, and the barrel fits the Glock 19 tested below. The Glock 19 barrel fits the Exodus as well. The slides do not interchange, but then the Glock is a Generation 5. The Exodus features angled cocking serrations front and rear. The slide has a modest lightening cut on each side and forward cocking serrations, which provide a modern look.
The slide is steel, and the frame is polymer. The grip frame is nicely checkered and pebbled in a pattern providing a good mix of abrasion and adhesion. The sides of the grip are similar to skateboard tape, but not as abrasive. The front has a reverse golf ball pattern. Both slide and frame are free of sharp edges. The pistol features a nicely designed magazine well, which is finished a bit differently than the grip frame.
During the firing test, the raters executed speed loads quickly with the GForce. We found the magazine well comparable to the slightly flared Glock 19 Generation 5 grip well. The frame features a standard light rail.

Internally, the pistol is all Glock. Rack the slide, and the striker is partially prepped against spring pressure. Press the trigger to move the striker to the rear, and the striker breaks against spring pressure and the pistol fires. The trigger action is sharp and breaks cleanly at 6.0 pounds. Reset is rapid. This is compared to the Glock 19 tested, which breaks at 5.8 pounds. After the initial firing test, we experimented enough to ensure the pistol would accept a Timney Red Glock trigger on hand, but we did not proceed to test the pistol with the trigger installed. It fits and functions.
Elsewhere, the pistol features Glock-type controls. The magazine release is standard Glock, and the slide lock is not ambidextrous. The magazine catch features what is termed a protective shelf on the grip.
Take down is pure Glock. Be certain the pistol is unloaded. Remove the magazine. Force the twin spring-loaded levers down, press the trigger, and the slide runs off the frame. Pick out the recoil-spring guide rod — which interchanges with the Glock — and then the barrel. The slide features an optics-ready cut. Remove the cover, and you may mount an RMR-pattern direct-mount reflex sight. The pistol does not accept Glock MOS plates and is not as versatile as the Glock. Similarly, the Canik also features a direct mount, and more aftermarket support favors the Canik.
The Exodus sights are a pleasant surprise. The front sight is a red fiber optic, while the rear features two green fiber-optic dots. The rear of the U-notch sight is serrated to reduce glare. The U-notch makes for real speed in fast shooting, we found.
The Exodus pistol is supplied with two magazines, neither Glock nor MagPul manufacture. They look like the Glock’s but are not quite exactly the same. They are polymer with a metal insert. Unexpectedly, the pistol worked fine with the supplied magazines and Glock MagPul magazines that we had on hand. Glock magazines tended to stick in place in the Exodus and had to be forced from the magazine well. We cannot quite explain this because we have used MagPul and Glock magazines together for years. This hurts the Exodus pistol’s utility because Glock magazines are famously reliable and widely distributed.
When racking the Exodus slide, we thought this pistol felt very tight, more so than any other Glock clone we have handled. It took more force to rack this slide than either of the other handguns. Also, the pistol doesn’t take grip inserts, another difference from the Glock.
We began the shooting tests with the Exodus 9mm. In firing the pistol for combat shooting, we fired at man-sized targets at 5, 7, and 10 yards, and also Bullseye targets at 10 yards off hand. We quickly determined the pistol fires low at 10 yards, about 3 inches low with most loads. But worse, we experienced several short cycles and failures to fully chamber rounds. These were usually during the first cartridges in the magazine and added up to five or six short cycles in every magazine. Was this related to the tighter fitting?
We doubled down and made certain we had a tight grip, and we switched between Exodus and MagPul magazines. The pistol had failed to fully cycle about a third of the time, but we got the last 20 rounds out without a stoppage. We stopped and stripped and cleaned the pistol, but considering it had run through the last 20 rounds without fail, we figured it was a break-in malfunction. Such break-in problems with polymer-frame pistols are rare. We are not certain we have encountered such a break-in ourselves.
After cleaning, we began again. This time the pistol sailed through a 50-round box of Blazer ammunition without fail. This tilted the test a little, and we went beyond the test specifications but confirmed this tight pistol may need a break-in period.
Next, we fired the pistol with 20 rounds of Black Hills 115-grain EXP. This is a load intended to generate as much velocity as possible without resorting to +P pressure. Recoil was increased but was not snappy. Function was normal. In combat shooting, the pistol did well, but it was behind the other handguns.
Because these are compact not subcompact handguns, we fired for accuracy from a solid benchrest at 25 yards. Firing the CCI Blazer, Black Hills EXP, and Fiocchi Covert X 124-grain loads, we tested the GForce’s accuracy. The pistol was not impressive. All shots fired low, 3 to 3.5 inches, at 25 yards. The average group was nearly 4 inches.
Our Team Said: The GForce Exodus is an interesting handgun, and it might be worth the money, but it is not as highly developed as the other handguns. We’re hard-pressed to see how we would choose it over the Canik.
| 9MM LUGER RANGE DATA | |||
|---|---|---|---|
| Black Hills Factory New 115-grain EXP JHP | GForce Exodus | Glock 19 Gen 5 | Canik Mete SF |
| Average Velocity | 1169 fps | 1178 fps | 1186 fps |
| Muzzle Energy | 349 ft.-lbs. | 354 ft.-lbs. | 359 ft.-lbs. |
| Smallest Group | 3.5 in. | 2.0 in. | 1.6 in. |
| Average Group | 4.5 in. | 2.7 in. | 2.5 in. |
| CCI Blazer 115-grain FMJ | GForce Exodus | Glock 19 Gen 5 | Canik Mete SF |
| Average Velocity | 1130 fps | 1145 fps | 1156 fps |
| Muzzle Energy | 326 ft.-lbs. | 335 ft.-lbs. | 341 ft.-lbs. |
| Smallest Group | 3.5 in. | 2.0 in. | 1.9 in. |
| Average Group | 4.1 in. | 2.7 in | 2.4 in. |
| Fiocchi Covert X 124-grain JHP | GForce Exodus | Glock 19 Gen 5 | Canik Mete SF |
| Average Velocity | 1090 fps | 1119 fps | 1095 fps |
| Muzzle Energy | 327 ft.-lbs. | 345 ft.-lbs. | 330 ft.-lbs. |
| Smallest Group | 2.5 in. | 2.3 in. | 1.6 in. |
| Average Group | 3.6 in. | 2.7 in. | 2.4 in. |
To collect accuracy data, we fired five-shot groups from a bench using an MTM Case-Gard K-Zone rest. Distance: 25 yards. We measured velocities with a Competition Electronics Pro Chrony with the first screen 10 feet from the muzzles.
Written and photographed by Robert Campbell, using evaluations from Gun Tests Team members. GT























